BetaFPV BT2.0 Female (LiPo)
0.92€
- PLN: zł 4.00
9A discharge and 15A burst output, twice as much compared to PH2.0.
Bt20 is more robust, unlike PH2.0 it is designed to be plugged and unplugged many times.
Lower resistance connection BT2.0 provides, gives You longer flight times and more confidence.
1 in stock
Description
BetaFPV BT2.0 Female connector (LiPo Batteries)
BetaFpv BT2 0 connector is the best option when it comes to battery connector for Tiny Whoops and Toothpicks. BT2.0 is robust. Unlike PH2.0, it does not wear out so quickly.
The most important is that BT2.0 supports up to 9A continuous discharge with up to 15A burst output. This gives You more power in Your Tiny Whoop, or 1s drone exactly when You need it the most. Comparing to PH2.0 which is 4.5A maximum.
BT 2.0 Bullet Points:
- BT2.0 is 9A discharge and 15A burst output, it is twice as much compared to PH2.0.
- Bt20 is more robust, unlike PH2.0 it was designed to be plugged and unplugged many times.
- Lower resistance connection BT2.0 provides, gives You longer flight times and more confidence.
BT2 0 cons and soldering:
To reduce weight BetaFPV placed the pins of connectors really close together. It’s easy to short both pins while soldering it to a PCB. CleanBoard Tiny – which has dedicated places to solder BT2.0 to – has a unique shade pads to make it easier for beginners to solder.
<CleanBoard Tiny soldering BT2.0 Placeholder>
Consider soldering only outer part of each connector pin as shown in the picture above to avoid unwanted shorts on the connector. Due to our extensive testing this kind of soldering is more than enough for currents that is usually used for charging with CleanBoard Tiny.
Male and Female:
Male connector is the one that You need for CleanBoard Tiny. It’s the same as You use on pigtail of Your FPV Drone.
Female connectors are usually used for batteries.
CleanBoard Tiny 1s charging board
and CleanBoard Tiny Protective Foam
Check Other Boards too:
You must be logged in to post a review.
Reviews
There are no reviews yet.